SKU 39955
For technical questions, please call 1-800-444-3353.
Page 2
THANK YOU for choosing a
HARBOR FREIGHT TOOLS product. For future reference, please complete the
owner’s record below:
Model____________ Serial No. ______________
Purchase Date _______________
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire
manual to become familiar with the unit BEFORE you begin assembly.
Technical Specifications
Tool Name:
20” Production Drill Press
Item Number:
39955
Power Source:
120V/ 60 Hz, Single Phase
Motor:
1-1/2 HP
Speeds in RPM:
180, 310, 320, 500, 540, 570, 1180, 1565, 1805, 2190, 2795, 3865
Spindle Stroke:
4”
Spindle:
MT3
Swing:
20”
Column Diameter:
3-5/8”
Chuck Capacity:
5mm to 20mm (.197” to .787”) JT3 Taper
Max. Spindle to Base:
45-1/4”
Spindle to Table:
26-1/8”
Table:
16-3/4” x 1-11/16”
Wet Table:
With Oiler
Table Slot:
1” x 1/2”
Warning:
The warnings, cautions and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS WHICH CANNOT BE BUILT INTO THIS PRODUCT, BUT
MUST BE SUPPLIED BY THE OPERATOR.
The Operator
PLEASE REMEMBER:
Do not operate the product if under the influence of alcohol or drugs. Read warning labels on prescriptions to
determine if your judgment/reflexes might be impaired.
Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective gloves and nonskid footwear is recommended.
Wear restrictive hair covering to contain long hair.
Use eye and ear protection. Always wear ANSI approved impact safety goggles and
dust mask or respirator when working around metal, wood and chemical dusts and mists.
Wear a full face shield if your are producing metal or wood filings.
Do not reach over or across running machines.
Maintain proper footing and balance at all times.
REV 05l
