Page 13
SKU 45656
For technical questions, please call 1-800-444-3353.
ClEANING AND MAINTENANCE
1.
WARNING:
Always disconnect the Tire Changer from its air supply source.
Pump the Bead Breaker Pedal (26E) several times to evacuate all compressed
air from the machine, and disconnect the unit from its electrical supply source
before performing any services or maintenance.
(See Figures A, B, and E.)
2.
Before each use, inspect the general condition of the Tire Changer. Check for
loose screws, misalignment, binding of moving parts, broken parts, loose or
damaged air supply hose/electric power cord, and any other condition that may
affect its safe operation. If abnormal noise or vibration occurs, disconnect the
Tire Changer from its air and electric supply sources immediately and have the
problem corrected before further use. Do not use damaged equipment.
(See
“Troubleshooting” guide.)
3.
At least once per week,
clean the Turntable (1C) with detergent or a
nonflammable solvent. Also, grease the Jaw Guides (17C).
4.
At least once per month,
check the oil level in the Lubricator Tank. If necessary,
remove the Oil Cap, fill the Tank with SAE 30 oil, and replace the Oil Cap. Also,
make sure that one drop of oil is injected into the Tank every 3-4 times the Bead
Breaker Pedal (26E) is depressed. If necessary, regulate the rate of oil injection
with the Oil Regulator Screw.
(See Figures B, E, and l.)
5.
After the first 20 days of use,
retighten the Jaws Tightening Screws (14C) and
the Screws (10C) located on the Turntable Slides.
(See Figure E, and Assy.
Diagram C.)
