Central Machinery 60238, Owner'S Manual & Safety Instructions

Page 8

For technical questions, please call 1-800-444-3353.

Item 60238 

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this 

manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: 

Turn the Power Switch of the tool off and unplug the tool from its electrical 

outlet before performing any procedure in this section.

TO PREVENT SERIOUS INJURY: 

DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.  

Moving guards must move freely and close instantly.

Table Adjustment

1.  Adjust the Table (54) by loosening the 

Pivot Lever (51), moving the Table, 

and tightening the Pivot Lever.

2.  Tilt the Table by loosening the Angle Bolt (56) and 

tilting to the required angle.   

The angle can be read using the Angle Scale (53).

3.  TO ENSURE THAT THE DRILL IS ENTIRELY 

PERPENDICULAR TO THE TABLE, 

insert a straight round bar (not included) 

in the Chuck (72), place a square on the 

Table (54) and bring it up to the round bar.  

Adjust the angle as needed.

CAUTION!  To prevent injury from unexpected 

Table movement, tighten Angle Bolt (56) 

and Pivot Lever (51) after adjustment.

Column (8)

Table 

Support (52)

Pivot 

Lever (51)

Angle Bolt (56) 

under Table

Figure D:  Table Adjustment

Setting a Drilling Depth

Located around the Spindle Feed Shaft is a 

Depth Stop Collar (A) with a scale.  The collar is 

capable of turning about the shaft, and may be 

locked in place by a Locking Screw (B).

1.  Lower the drill (with the power OFF) so that it 

contacts the material and hold in that position.

2.  Loosen the locking screw and turn the collar 

so that the measurement for the depth of the 

hole required is in line with the pointer (C). 

3.  Lock the collar in this position using the locking screw.

Figure E:  Drill Depth Adjustment

SAFETY

OPERA

TION

MAINTENANCE

SETUP