SKU 91977
Page 6
For technical questions, please call 1-800-444-3353
7.
Place the point of the drill bit at the spot you wish to drill. When it is safe to do
so, squeeze the Trigger (24). The Drill will begin to operate, and the drill bit will
begin to drill into the work material. Drill until you have reached the desired
depth. Release the Trigger (24) to cease operation of the drill.
WARNING: This drill operates at non-variable speed. That means once the Trigger
is squeezed it will begin to operate at full speed. When the trigger is released it will
stop operating. Be prepared for the drill to operate at full speed immediately
when the trigger is squeezed.
8.
In most cases, you will be able to simply retract the drill bit from the hole. If
the bit can not be easily pulled out of the hole, move the Direction Switch (30)
to the RIGHT to reverse direction of the drill. Squeeze the Trigger (24) to
operate the drill, and pull the bit out of the hole as it rotates counterclockwise.
NOTE: To extend the life of your tool, wait for the drill to stop rotating before moving
the Direction Switch to reverse direction. Operating the Direction Switch while
the drill is still turning may cause damage to the tool.
9.
When you are done, disconnect the Drill from the air supply, and store it
properly.
Maintenance
1.
After each use, wipe the tool with a clean cloth to remove any dirt, oil or other
contaminants.
2.
If an automatic oiler is not being used, always add a few drops of pneumatic
oil (available from Harbor Freight Tools) to the air line before each use.
3.
After each use, drain any collected water from the air compressor tank, air
lines and filter. Before each use recheck these to be sure they are dry.
Accumulated moisture can cause rusting and corrosion of your compressed
air equipment.
