SKU 95346
for technical questions, please call 1-800-444-3353
PAGE 13
tROUbLESHOOtING
Problem
Possible cause
Possible Solution
Engine will not start.
Low or no fuel in fuel tank or
1.
improper fuel/2-cycle oil mix.
Not enough fuel getting to
2.
carburetor.
Faulty spark plug.
3.
Contaminated fuel.
4.
Insufficient electrical current
5.
getting to spark plug.
Fill fuel tank with proper 25:1 unleaded
1.
gasoline/2-cycle oil mix.
Press primer 3-4 times. Set choke to
2.
“START”. Then attempt to start engine.
Clean or replace spark plug.
3.
Have a qualified service technician
4.
empty old fuel from fuel tank. Then, refill
fuel tank with fresh fuel mixture.
Have a qualified service technician
5.
inspect electrical system.
Engine runs, but auger
not rotating.
Speed control not properly
1.
used.
Speed control cable not
2.
properly adjusted.
Auger stuck in rocks, roots,
3.
etc.
Make sure to fully squeeze the speed
1.
control.
Have a qualified service technician
2.
adjust speed control cable.
Remove auger from hole and clear hole
3.
of obstructions.
Auger rotates while
engine is at idle.
Engine idle speed set too high.
Have a qualified service technician reset
carburetor idle adjustment screw to lower
idle (RPM) speed.
Gearbox feels
exceptionally hot to the
touch.
Low gear oil.
Immediately turn off Auger Drill. Allow
gearbox to completely cool. Then, fill
gearbox with SAE 80-90 gear oil.
Kill switch does not turn
off engine.
Faulty kill switch.
Immediately remove spark plug cap from
spark plug to stop engine. Discontinue
using Auger Drill until the tool is repaired by
a qualified service technician.
PLEASE READ tHE fOLLOWING cAREfULLy
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROvIDED THE PARTS LIST AND ASSEM-
BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Record
Product’s Serial Number Here:
Note:
If product has no serial number, record month and year of purchase instead.
Note:
Some parts are listed and shown for illustration purposes only, and are not available
individually as replacement parts.
REV 07e
