Page 3
SKU 98117
For technical questions, please call 1-800-444-3353.
assembly instructions
Attach one Rubber Foot Pad (7) to
1.
bottom of each support leg on Base
(1).
Place Base (1) on flat, level surface
2.
and attach Vertical Tube (2) to Base
(1) using Hex-Head Screw (10) and
Flat Washer (13) and securely tighten
to prevent wobble when attaching
other parts.
Slide the Adjustable Tube (4) into the
3.
Vertical Tube (2). Leave approxi-
mately three inches of the Adjustable
Tube (4) sticking out of the Vertical
Tube (2). Secure the Adjustable Tube
(4) in place using the Knob (8).
Thread the Bracket Tube Holder (15)
4.
into the top of the Adjustable Tube
(4), using 2 recessed Head Screws
(12). Tighten securely but do not over
tighten.
Attach The Vacuum Tube (14) to the
5.
Bracket Tube Holder (15) using the
Attachment Bolt (5) and Sliding Bar
(6) to tighten. Do not over tighten.
Slide the Dust Collector Head (11)
6.
into the Vacuum Tube (14). Tighten
the Lock Knob (16) to hold the Dust
Collector Head (11) in place.
Recheck all Nuts, Handles and Knobs
7.
for security before using.
operation instructions
Adjust height of Dust Collector Head
1.
(11) by raising or lowering the Adjust-
able Tube (4). Loosen the Knob (8) to
raise or lower. Tighten the Knob (8)
to hold the Adjustable Tube (4) at the
selected height.
Adjust the Angle of the Vacuum Tube
2.
(14) by loosening the Attachment Bolt
(5). Set the needed angle and use
the Attachment Bolt (5) to retighten.
Adjust the Angle of the Dust Col-
3.
lector Head (11) by loosening the
Lock Knob (16), setting the needed
angle and retightening the Lock Knob
(16).
note: the lock knob (16)
will thread into an existing hole if
needed to secure the dust collec-
tor head in the horizontal position.
if another angle is needed, thread
the lock knob against the neck
of the dust collector head tight
enough to prevent movement.
Position the Dust Collector Head (11)
4.
as close to the area where most of the
dust from your project will accumu-
late being careful to stay clear of all
belts, disks, and other moving parts
associated with the cutting, sanding
or grinding tool you are using. This
includes leaving space to use your
hands without coming in contact with
the Dust Collector Head (11).
Follow all manufacturer’s instructions
5.
and safety warnings when using any
tool with this Vacuum Dust Collector.
Never place the Dust Collector Head
close to moving parts.
This Vacuum Dust Collector has a
6.
4” Vacuum Tube (14). In order to
connect a dust collecting system with
other than a 4” attachment, you must
have a 4” to 3” or 2” adapter. NOTE:
Using a smaller hose and duct tape to
prevent air leakage is not acceptable,
or safe.
Always re-check all knobs, bolts and
7.
nuts for security before using this tool.
