Page 14
For technical questions, please call 1-800-444-3353.
SKU 44505
troubleshooting
Problem
Possible causes
likely solutions
Tool will not start.
Cord not connected.
1.
No power at outlet.
2.
Internal damage or wear.
3.
Check that cord is plugged in.
1.
Check power at outlet. If outlet is unpowered,
2.
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity for
tool and circuit has no other loads.
Have technician service tool.
3.
Tool operates slowly. Extension cord too long or wire size
too small.
Eliminate use of extension cord. If an extension
cord is needed, use shorter/heavier gauge cord.
See
Extension Cords
in
GROUNDING
section.
Performance
decreases over time.
Accessory dull or damaged.
1.
Carbon brushes worn or
2.
damaged.
Keep cutting accessories sharp. Replace as
1.
needed.
Have qualified technician replace brushes.
2.
Excessive noise or
rattling.
Belt too loose (slipping) or too
1.
tight (bearing damage).
Spindle dry
2.
Loose spindle pulley
3.
Loose motor pulley
4.
Internal damage or wear.
5.
Properly tension belt.
1.
Lubricate spindle
2.
Check pulley nut
3.
Tighten Set screws
4.
Have technician service tool.
5.
Overheating.
Forcing machine to work too fast.
1.
Accessory misaligned.
2.
Accessory dull or damaged.
3.
Blocked motor housing vents.
4.
Motor being strained by long or
5.
small diameter extension cord.
Allow machine to work at its own rate.
1.
Check and correct accessory to table alignment.
2.
Keep cutting accessories sharp. Replace as
3.
needed.
Wear ANSI-approved safety goggles and NIOSH-
4.
approved dust mask/respirator while blowing dust
out of motor using compressed air.
Eliminate use of extension cord. If an extension
5.
cord is needed, use one with the proper diameter
for its length and load. See
Extension Cords
in
GROUNDING
section.
Drill bit burns or
smokes
Incorrect spindle speed
1.
Dull drill bit
2.
Drilling too slowly
3.
Lacking lubrication
4.
Change spindle speed
1.
Replace with new bit
2.
Drill faster
3.
Lubricate cutting area
4.
Drill bit wobbles
Bent bit
1.
Worn Spindle Bearings
2.
Drill bit not in Chuck correctly
3.
Chuck not properly installed
4.
Replace drill bit
1.
Replace spindle bearings
2.
Reinstall drill bit
3.
Reinstall Chuck and Arbor assembly
4.
Feed Wheel returns
slowly, or too fast
Tension Spring not in adjustment
Adjust Tension Spring.
Drill bit binds
Workpiece pinching drill bit
1.
Dull drill bit
2.
Feed pressure too hard
3.
Belts loose
4.
Reposition workpiece, lubricate drill
1.
Replace drill bit
2.
Pull Feed Handle slowly.
3.
Adjust motor and spindle belt tension
4.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
