Page 7
SKU 92918
For technical questions, please call 1-800-444-3353.
Loading Coil Nails
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN
RELOADING OR DOING ANY OTHER MAINTENANCE ON THIS TOOL.
Other people in the work area must also wear ANSI approved impact safety
goggles.
Warning! Make sure the Nailer is not attached to the air hose whenever loading it.
1.
Rotate the Trigger Lock (28) to the locked position, as shown on page 6 and
below.
To open the Canister (100), press down on the Door Latch (32) and swing
the Door (34) and Canister Cover (94) open.
2.
Check the Canister Platform (96) inside the Canister (100). The Platform can be
adjusted up and down to use various lengths of nails from 1
1
/
4
”* to 2
1
/
2
”:
*To help prevent jamming, nails under 1
3
/
4
” must be wire collated.
A. For 1
1
/
4
” to 1
1
/
2
” Long Nails: Use first (top) setting
B. For 1
5
/
8
” to 1
3
/
4
” Long Nails: Use second setting
C. For 2” to 2
1
/
4
” Long Nails: Use third setting
D. For 2
3
/
8
” to 2
1
/
2
” Long Nails: Use fourth (bottom) setting
3.
Place a coil of nails around the Canister Platform (96) in the Nail Canister (100).
4.
Uncoil enough nails to reach the Feed Pawl (87). Place the
second nail on the coil
between the teeth of the Feed Pawl, making sure the nail head fits in the slot in the
upper portion of the Feed Pawl.
5.
Swing the Canister Cover (94) closed. Then, close the Door (34). Make sure the
Door closes securely. If it does not engage, the nail head is not in the slot in the
upper portion of the Feed Pawl (87).
CANISTER
COVER (94)
CANISTER (100)
NAILS
CANISTER PLATFORM (96)
(LIFT AND TURN
TO ADJUST)
DOOR
(34)
FEED
PAWL (87)
TRIGGER LOCK (28)
LOCKED
