UNPACKING
Your High Speed Cutter comes fully assembled. When unpacking your High Speed Cutter,
check to make sure the following parts are included. If any parts are missing or broken, please
call Harbor Freight Tools at the number on the cover of this manual.
ASSEMBLY
Your High Speed Cutter comes completely assembled and is ready for use. Should you need to
remove and replace the CUTTING WHEEL (#33), refer to the steps below.
Step 1: Purchase an authorized replacement CUTTING WHEEL from Harbor Freight Tools. Use
only approved replacement accessories with your High Speed Cutter.
Step 2:Place the SPANNER (#32) on the flats of the
SPINDLE (#6).
Step 3: Insert the HEX WRENCH (#31) into the HEX SCREW
(#1) as shown in Figure 1.
Cutting Wheel (#33)
Spacer (#2)
Hex Screw (#1)
Hex Wrench (#31)
Figure 1 — Inserting the Hex Wrench
ITEM #
DESCRIPTION
N/A
High Speed Cutter
32
Spanner
31
Hex Wrench
CAUTION
Use only 3" Cutting
Wheels rated for more
than 18,000 RPM.
Page #4 -- SKU: 05490
