Step 3:Remove the Brass Fitting from the Air Outlet Nipple on the Air Brush Compressor
as shown in Figure 2.
Figure 2 — Attaching the Air Conduit
Step 4:Place the Brass Fitting removed in Step 3 onto the bare end of the AIR CONDUIT
(#7). Make sure the threads of the Brass Fitting face toward the end of the AIR CONDUIT.
Step 5:Place the bare end of the AIR CONDUIT over the end of the Air Outlet Nipple. Make
sure the AIR CONDUIT is pressed over the ridge in the Air Outlet Nipple as shown in
Figure 2.
Step 6:Thread the Brass Fitting from Step 4 onto the threads of the Air Outlet Nipple. Tighten
snuggly, but do not over tighten as you may damage the AIR CONDUIT.
Your Air Brush Compressor is ready for use.
OPERATION
Step 1:Connect your air brush to the Brass Fitting at the end of the AIR CONDUIT (#7).
Tighten as appropriate.
Step 2:Plug the Power Cord into an appropriate outlet.
Step 3:To operate the Air Brush Compressor, flip the Switch to the ON or “l” position.
Page 6 -- SKU: 34844
