Page 15
For technical questions, please call 1-888-866-5797.
Item 42202
Troubleshooting
Problem
Possible Causes
Likely Solutions
Decreased output. 1. Not enough air pressure and/
or air flow.
2. Obstructed trigger.
3. Blocked air inlet screen (if
equipped).
4. Air leaking from loose housing.
5. Mechanism contaminated.
6. Damaged or kinked air/
abrasive hose.
1. Check for loose connections and make sure
that air supply is providing enough air flow
(CFM) at required pressure (PSI) to the
tool’s air inlet.
Do not exceed maximum air
pressure.
2. Clean around trigger to ensure free
movement.
3. Clean air inlet screen of buildup.
4. Make sure housing is properly assembled
and tight.
5.
Have qualified technician clean and lubricate
mechanism. Install in-line filter in air supply
as stated in Initial Set Up: Air Supply.
6. Inspect and replace hose.
Housing heats
during use.
1. Worn parts.
2. Long periods of continuous
usage.
1.
Have qualified technician inspect internal
mechanism and replace parts as needed.
2. Use intermitantly, allowing cool-off periods.
Severe air
leakage.
(Slight air leakage
is normal,
especially on older
tools.)
1. Cross-threaded housing
components.
2. Damaged valve or housing.
3. Dirty, worn or damaged valve.
1. Check for incorrect alignment and uneven
gaps. If cross-threaded, disassemble and
replace damaged parts before use.
2. Replace damaged components.
3. Clean or replace valve assembly.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect air supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.