background image

SKU 42321

For technical questions, please call 1-800-444-3353.

Page 8

Operation

Caution: Prior to use, inspect the compressor or any damaged parts or unsafe condi-
tions. Make any necessary repairs before using again.

Turning Compressor On

1.

Verify Tank Drain Valve (A-7) is closed.

2.

Verify oil level is correct.

3.

Verify that the Safety Valve (A-4) is operational.

4.

Turn the Air Flow Valve (A-8) to the OFF position.

5.

Plug the power cord into a electrical outlet with a grounding prong.

6.

      Turn

 the ON/OFF Switch 

Lever

(A-5)

 down 

to turn on.  

Turn

 the Switch

 Lever up

 

to shut off.

Allow the pressure to build up to at least 80 PSI before using air.

7.

Open the Air Flow Valve (A-8) and check for air leaks.

The operation of the compressor is automatic, as controlled by the an internal pressure

switch. When the pressure drops below its operating range the compressor turns on.
When the pressure is above 115 PSI, the compressor shuts off.

Warning; The compressor may become very hot during operation. Do not touch the
cylinder area of the compressor, or allow flammable materials to come in contact with
the cylinder area.

Adjusting Pressure Gauge and Pressure Adjustment Screw

Caution: The Pressure Switch is adjustable but changes to the pressure levels are not
recommended; any change to the automatic ON/OFF pressure levels will cause addi-
tional stress on the motor which may shorten motor life.

Adjusting Air Output

1.

When the

 Lever of the

 Air Flow Valve (A-8) is to the 

up or down position,

 the 

valve is closed.

 

When it is in the 

middle, it is open.

2.

Turn the Air Flow Valve to the appropriate pressure.

Maintenance

Warning: Do not make any repairs, adjustments, or maintenance on the air compressor
unless it is disconnected from the electrical power and the tank pressure is released.

Maintenance should always be performed by a qualified technician.

1.

Check the oil level before each use. If the oil is low, add some. If it is high, drain some

by removing the Drain Plug. Replace the oil once a year.

2.

Check and clean the Air Filter (B-5) every 50 hours, or sooner if used in a dusty

environment.

REV 02/04

Summary of Contents for 42321













Reviews: