2.
Turn the Tool Pressure Adjuster Valve (part #59)
clockwise
all the way to allow
compressed air to build up in the Air Tank (part #41).
(See Figures D, and J.)
3.
Connect the air hose (not provided) to the previously installed 1/4” NPT Female
Quick Coupler on the Tool Pressure Adjuster Valve (part #59). Then, connect the
other end of the air hose to the pneumatic tool (not provided) that is to be used.
(See Figures C and D)
4.
Plug the Power Cord (part #72) into a grounded, three-hole electrical outlet.
(See
Assy. Diagram.)
5.
Pull
up
on the Tool Pressure Adjuster Valve (part #59) to turn the Air Compressor
on
. (Push
down
on the Tool Pressure Adjuster Valve to turn the Air Compressor
off
.)
(See Figures C and J)
6.
Allow sufficient time for the Tank Pressure Gauge (part #56) to indicate
80 PSI
before using the Air Compressor.
(See Figure I)
RESET BUTTON
TOOL
PRESSURE
GAUGE
(#60)
SAFETY
RELIEF
VALVE (#57)
TANK
PRESSURE
GAUGE
(#56)
AIR TANK (#41)
FIGURE J
SKU 47915
PAGE 10
TOOL
PRESSURE
ADJUSTER
VALVE (#59)