FIGURE C
16.
WARNING:
People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List on page 14
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional references to the parts listed below, refer to the
Assembly
Diagram on page 15.
1.
Prior to using, the Air Compressor requires the attachment of a
1/4” NPT Female
Quick Coupler
(not provided) to the Tool Pressure Adjuster Valve (part #59). To
do so, wrap approximately 4” of thread seal tape around the male threads of the
Tool Pressure Valve Adjuster. Then, wrench tighten the Quick Coupler onto the
Tool Pressure Valve Adjuster.
(See Figure D, next page.)
2.
To attach the Handle (part #50) to the Air Tank (part #41), insert each end of the
Handle into the mounting brackets on the Air Tank. Then, secure the Handle to
the Air Tank with two Plate Washers (part #65) and two Hex Head Bolts
(part #68).
(See Figure E, next page.)
SKU 47915
PAGE 6