TOOL PRESSURE
ADJUSTER VALVE
(#59)
1/4” NPT
FEMALE QUICK COUPLER
(NOT PROVIDED)
TOOL PRESSURE GAUGE
(#60)
HEX HEAD BOLT (#68)
PLATE WASHER (#65)
HANDLE (#50)
AIR TANK
(#41)
FIGURE F
FIGURE D
TANK WHEEL
BOLT (#42)
AIR TANK (#41)
3.
To attach the two Tank Wheels (part #43) to the Air Tank (part #41), insert a Tank
Wheel Bolt (part #42) through the hub of a Tank Wheel. Then, wrench tighten the
Tank Wheel Bolt onto the wheel bracket located at the back of the Air Tank.
Repeat this procedure for the remaining Tank Wheel.
(See Figure F.)
4.
To wire the Motor to accept
220 Volt
electrical power supply, remove the cover
from the
electrical junction box
on the Motor. Next, connect each of the
four
wires
within the Wire Cable (part #71) to its proper
electrical terminal
in the junc-
tion box. Then, reattach the cover to its junction box.
CAUTION: For your safety,
only a qualified, certified electrician should attach the Wire Cable to the
Motor’s junction box.
(See Figure G, next page.)
FIGURE E
SKU 47915
PAGE 7
TANK WHEEL
(#43)
Rev 01/03