FIGURE G
OPERATING INSTRUCTIONS
To Check And Fill The Oil Level:
1.
CAUTION: ALWAYS make sure the Air Compressor is filled to the proper
level with a
premium quality, 30-weight, non-detergent compressor oil
prior
to turning on the machine. Failure to do so will result in damage to the Air
Compressor and void its warranty.
2.
To check the level of oil in the Air Compressor, observe the Oil Sight Gauge
(part #26) located on the Crankcase (part #31). Proper oil level is
indicated when the oil appears in the
middle of the circle
in the Oil Sight Gauge.
(See Figure H, next page.)
3.
If the oil level is below the middle of the circle in the Oil Sight Gauge (part #26),
UNSCREW
(do not pull)
the Dip Stick (part #29) out of the Oil Fill Hole. Next,
add oil into the Oil Fill Hole until the level of oil reaches the middle of the circle as
indicated on the Oil Sight Gauge. Do not overfill. Then screw the Dip Stick back
into the Oil Fill Hole, being careful not to strip the plastic threads.
(See Figure H.)
SKU 47915
PAGE 8
JUNCTION BOX
5.
To wire the Motor to accept 120 Volt electrical power supply, remove the cover
from the electrical junction box on the Motor. Next, connect each of the four wires
within the wire Cable (part #71) to its proper electrical terminal in the junction
box. Then, reattach the cover to its junction box.
CAUTION: For your safety,
only a qualified, certified electrician should attach the Wire Cable to the
Motor’s junction box. (See Figure G)
WIRE CABLE (#72)
MOTOR
PRESSURE
SWITCH (#55)
Rev 01/03