Page 4
For technical questions, please call 1-800-444-3353.
Item 56101
21. Do not operate the equipment with known
leaks in the engine’s fuel system.
22. This product contains or, when used, produces a
chemical known to the State of California to cause
cancer and birth defects or other reproductive harm.
(California Health & Safety Code § 25249.5,
et seq.
)
23. When spills of fuel or oil occur, they must be
cleaned up immediately. Dispose of fluids and
cleaning materials as per any local, state, or
federal codes and regulations. Store oil rags in
a bottom-ventilated, covered, metal container.
24. Keep hands and feet away from moving parts. Do
not reach over or across equipment while operating.
25. Before use, check for misalignment or binding
of moving parts, breakage of parts, and any
other condition that may affect the equipment’s
operation.
If damaged, have the equipment
serviced before using.
Many accidents are
caused by poorly maintained equipment.
26. Use the correct equipment for the application.
Do not modify the equipment and do not use the
equipment for a purpose for which it is not intended.
Service Precautions
1.
Before service, maintenance, or cleaning:
a.
Turn the engine switch to its “OFF” position.
b.
Allow the engine to completely cool.
c.
Then, remove the spark plug
cap from the spark plug.
2. Keep all safety guards in place and in
proper working order. Safety guards include
muffler, air cleaner, mechanical guards, and
heat shields, among other guards.
3.
Do not alter or adjust any part of the equipment
or its engine that is sealed by the manufacturer
or distributor. Only a qualified service
technician may adjust parts that may increase
or decrease governed engine speed.
4. Wear ANSI-approved safety goggles, heavy-duty work
gloves, and dust mask/respirator during service.
5. Maintain labels and nameplates on the
equipment. These carry important information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
6. Have the equipment serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the equipment
is maintained. Do not attempt any service or
maintenance procedures not explained in this
manual or any procedures that you are uncertain
about your ability to perform safely or correctly.
7. Store equipment out of the reach of children.
8. Follow scheduled engine and equipment maintenance.
Air Compressor Safety Warnings
1. Risk of fire or explosion - Do not spray flammable liquid
in a confined area or towards a hot surface. Spray area
must be well-ventilated. Do not smoke while spraying
or spray where spark or flame is present. Arcing parts -
Keep compressor at least 20 feet away from explosive
vapors, such as when spraying with a spray gun.
2. Risk of bursting - Do not adjust regulator higher
than maximum stated pressure of attachment.
3. Risk of injury - Do not direct air
stream at people or animals.
4. Do not use to supply breathing air.
5. Do not use the air hose to move the compressor.
6. Drain Tank daily and after use. Internal rust
causes tank failure and explosion.
7.
Add correct amount of compressor oil before
first use and every use. Operating with the
incorrect amount of oil causes permanent
damage and voids warranty. To prevent
damage, do not use with overfilled or low oil.
8. Compressor head gets hot during operation.
Do not touch it or allow children nearby during
or immediately following operation.
9. Release the pressure in the storage
tank before moving.
10. The use of accessories or attachments not
recommended by the manufacturer may
result in a risk of injury to persons.
11. All air line components, including hoses, pipe,
connectors, filters, etc., must be rated for a minimum
working pressure of 125 PSI, or 150% of the
maximum system pressure, whichever is greater.
SAVE THESE INSTRUCTIONS.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
