Page 9
For technical questions, please call 1-888-866-5797.
Item 62380
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
Breaking in the compressor
1�
iMpOrtant: First, turn the
power Switch OFF (O).
2� Turn the pressure regulator knob fully
clockwise to open the air flow�
3� Plug in the power cord�
4� Open the drain valve completely�
5� Turn the Power Switch ON�
6� Let the unit run for 10 minutes�
Air will expel freely through the Drain Valve�
7� Place the switch in the OFF (O) position�
8� Close the drain valve�
air connection Setup
1� Connect a regulator valve, an inline shut off valve
and a 1/4″ NPT air hose to the Quick Coupler
(all sold separately)� The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working�
note:
an in-line shutoff ball valve is an important
safety device because it controls the air supply even
if the air hose is ruptured. the shutoff valve should
be a ball valve because it can be closed quickly.
2� Depending on the tool that will be used
with this compressor, incorporate additional
components, such as an in-line oiler, a filter,
or a dryer (all sold separately), as shown on
Figure A on page 10 and Figure B on page 11�
Consult air tool’s manual for needed accessories�
