Central Pneumatic 62913, Owner'S Manual & Safety Instructions

Page 11

For technical questions, please call 1-888-866-5797.

Item 62913 

SAFETY

Op

ERA

TION

M

AINTENANCE

INST

ALLA

TION

5.  To start a cold engine, move the Choke to the START 

(start/closed) position.  

To restart a warm engine, leave the 

Choke in the RUN position.

6. 

For MANUAL START

a.  Turn the Engine Switch to ON.

ON

OFF

START

ON

b.  Grip the Starter Handle of the Engine loosely and 

pull it slowly several times to allow the gasoline 

to flow into the Engine’s carburetor. Then pull 

the Starter Handle gently until resistance is felt. 

Allow Cable to retract fully and then pull it quickly. 

Repeat until the engine starts. Note: Do not let 

the Starter Handle snap back against the engine. 

Hold it as it recoils so it doesn’t hit the engine.

For ELECTRIC START

Turn the Engine Switch to START.

Note:

  To prolong starter life, use short starting 

cycles (5 seconds maximum).  Then wait one 

minute before attempting to start again.

ON

OFF

START

START

Note:

 If engine does not start, check engine oil. Engine 

will not start with low or no engine oil. 
7.  Allow the Engine to run for several seconds.  

Then, if the Choke lever is in the START position, 

move the Choke Lever very slowly to its RUN position. 

Note:

 Moving the Choke Lever too fast could kill the engine.

8.  Close the Pilot Valve by rotating it 

to a horizontal position.

5 

RUN

START

RUN

START

7 

8