Central Pneumatic 67853, Manual

Page 3

For technical questions, please call 1-800-444 3353.

Item 67853

24. Keep hands and feet away from moving parts.  Do not 

reach over or across equipment while operating.

25. Before use, check for misalignment or binding of 

moving parts, breakage of parts, and any other 

condition that may affect the equipment’s operation.  

If damaged, have the equipment serviced before 

using.

  Many accidents are caused by poorly 

maintained equipment.

26. Use the correct equipment for the application.  Do not 

modify the equipment and do not use the equipment for 

a purpose for which it is not intended.

Service Precautions

1. 

before service, maintenance, or cleaning:

a. 

Turn the engine switch to its “OFF” position.

b. 

Allow the engine to completely cool.

c. 

Then, remove the spark plug cap from the 

spark plug.

2.  Keep all safety guards in place and in proper working 

order.  Safety guards include muffler, air cleaner, 

mechanical guards, and heat shields, among 

other guards.

3. 

Do not alter or adjust any part of the equipment 

or its engine that is sealed by the manufacturer 

or distributor.  Only a qualified service technician 

may adjust parts that may increase or decrease 

governed engine speed.

4.  Wear ANSI-approved safety goggles, heavy-duty work 

gloves, and dust mask/respirator during service.

5.  Maintain labels and nameplates on the equipment.  

These carry important information.  If unreadable 

or missing, contact Harbor Freight Tools for 

a replacement.

6.  Have the equipment serviced by a qualified repair 

person using only identical replacement parts.  This will 

ensure that the safety of the equipment is maintained.  

Do not attempt any service or maintenance procedures 

not explained in this manual or any procedures that 

you are uncertain about your ability to perform safely 

or correctly.

7.  Store equipment out of the reach of children.
8.  Follow scheduled engine and equipment maintenance.

Air Compressor Safety Warnings

1.  Risk of fire or explosion - Do not spray flammable liquid 

in a confined area or towards a hot surface. Spray area 

must be well-ventilated. Do not smoke while spraying 

or spray where spark or flame is present. Arcing parts - 

Keep compressor at least 20 feet away from explosive 

vapors, such as when spraying with a spray gun.

2.  Risk of bursting - Do not adjust regulator higher than 

maximum stated pressure of attachment.

3.  Risk of injury - Do not direct air stream at people 

or animals.

4.  Do not use to supply breathing air. 
5.  Do not use the air hose to move the compressor. 
6.  Drain Tank daily and after use. Internal rust causes 

tank failure and explosion.

7. 

Add correct amount of compressor oil before first 

use and every use. Operating with the incorrect 

amount of oil causes permanent damage and voids 

warranty. To prevent damage, do not use with 

overfilled or low oil. 

8.  Compressor head gets hot during operation.  Do not 

touch it or allow children nearby during or immediately 

following operation.

9.  Release the pressure in the storage tank 

before moving.

10. The use of accessories or attachments not 

recommended by the manufacturer may result in a risk 

of injury to persons. 

11.  All air line components, including hoses, pipe, 

connectors, filters, etc., must be rated for a minimum 

working pressure of 125 PSI, or 150% of the maximum 

system pressure, whichever is greater. 

 SAVE THESE 

INSTRUCTIONS.