Page 4
For technical questions, please call 1-888-866-5797.
Item 93657
Air Compressor Safety Warnings
1.
Risk of fire or explosion - do not spray
flammable liquid in a confined area or towards a
hot surface. Spray area must be well-ventilated.
Do not smoke while spraying or spray where
spark or flame is present. Arcing parts - keep
compressor at least 20 feet away from explosive
vapors, such as when spraying with a spray gun.
2.
Risk of bursting - do not adjust regulator higher
than marked maximum pressure of attachment.
3.
Risk of injury - do not direct air
stream at people or animals.
4.
Do not use to supply breathing air.
5.
Do not leave compressor unattended
for an extended period while plugged in.
Unplug compressor after working.
6.
Keep compressor well-ventilated.
Do not cover compressor during use.
7. Drain Tank daily and after use.
8. Do not remove the valve cover or
adjust internal components.
9. Compressor head gets hot during operation.
Do not touch it or allow children nearby
during or immediately following operation.
10. Do not use the air hose to move the compressor.
11. The use of accessories or attachments not
recommended by the manufacturer may
result in a risk of injury to persons.
12. All air line components, including hoses, pipe,
connectors, filters, etc., must be rated for a minimum
working pressure of 150 PSI, or 150% of the
maximum system pressure, whichever is greater.
13. USE OF AN EXTENSION CORD IS NOT
RECOMMENDED. If you choose to use an
extension cord, use the following guidelines:
TABLE A: RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25′
50′
100′
150′
0 – 6
18
16
16
14
6.1 – 10
18
16
Do not use.
10.1 – 12
16
16
Do not use.
12.1 – 16
14
12
Do not use.
a. Make sure your extension cord
is in good condition.
b. Be sure to use an extension cord which
is heavy enough to carry the current your
product will draw. An undersized cord will
cause a drop in line voltage resulting in loss
of power and overheating. Table A shows the
correct size to use depending on cord length
and nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
14. Industrial applications must follow OSHA guidelines.
15. Maintain labels and nameplates on the
compressor. These carry important safety
information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
16. This product is not a toy.
Keep it out of reach of children.
17. Operate unit on level surface.
18. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
19.
This Compressor will automatically shut
off on overload or under excessive heat.
Should this occur, turn the Power Switch (34) to
its “OFF” position. Wait until the Compressor
cools. Then, turn the Power Switch to
its “ON” position to resume work.
20.
Spray painting only.
Never use this unit with
gasoline, kerosene, or any other flammable solvent.
SAVE THESE INSTRUCTIONS.
SAFETY
OPERA
TION
MAINTENANCE
SETUP
