SKU 94275
For technical questions, please call 1-800-444-3353.
PAGE 10
How To Install The Dust Reclaimer To A Wall
Open the right side door（of the blast cabinet. Remove the four screws on the ex-
1.
haust board. Take out the exhaust board (see Figure 1).
Install the Hose Connector (48) using four M5x12 bolts (47) as shown in Figure 2
2.
below.
Re-install the Exhaust Board over the Hose Connector (48) (see Figure 1).
3.
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Exhaust Board
IMPORTANT: The Wire Mesh Reinforced Hose (16B) supplied with the Dust Reclamer
is
3 feet long. When determining a permanent location for the Model 94274 Blast Cabi-
net, make sure the Blast Cabinet is
within 3 feet of the wall surface on which the Dust
Reclaimer will be mounted.
(See Figure 7, page 13).
NOTE: You may wish to connect a
longer
Wire Mesh Reinforced Hose (not included
between the Blast Cabinet and Dust Reclaimer. If so, make sure the longer Hose has a
2” diameter, and use a proper extension cord to connect the Power Cord Plug (12) of
the Dust Reclaimer to the Lamp Housing on the Blast Cabinet.
The Dust Reclamer Kit can be attaced to a wall surface (see instructions below), or it
can be mounted to the back of SKU 94274 Blast Cabinet. See page 14.
