Page 8
For technical questions, please call 1-800-444-3353.
SKU 95275
Assembly
Break in the new Air Compressor as
1.
follows:
Make sure the Switch is OFF and the
a.
unit is unplugged. Insert a male coupler
(sold separately) into the female Quick
Coupler and fully open all regulators
and valves.
Plug in the Power Cord.
b.
Turn the Switch ON (the
c.
|
position)
and press the Reset button next to the
Switch.
Let the unit run for 30 minutes. Air will
d.
expel freely through the Coupler.
Turn the Switch OFF.
e.
Unplug the Power Cord and remove the
f.
male coupler.
Typical Air Line Setup
Recommeded Accessories
1/4” Air Hose
•
Set of 1/4” Male and Female Quick Couplers
•
Inline Desiccant Dryer/Filter or Water Filter
•
Female
Quick Coupler
Female
Quick Coupler
1/4” Air Hose
Water Filter
(Airbrush Use)
Male
Quick
Coupler
Male
Quick
Coupler
Air
Compressor
Tool
2. Connect a regulator valve, an inline
shut off valve and a 1/4” NPT air hose
to the Quick Coupler. The air hose must
be long enough to reach the work area
with enough extra length to allow free
movement while working.
Note:
An in-line shutoff ball valve is an
important safety device because it
controls the air supply even if the air
hose is ruptured. The shutoff valve
should be a ball valve because it can
be closed quickly.
Depending on the tool which you will
3.
be using with this compressor, you
may need to incorporate additional
components, such as an in-line oiler,
a filter, or a dryer (all sold separately).
Consult your air tool’s manual for needed
accessories.
GENERAL OPERATING
INSTRuCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
1. Turn red regulator knob counterclockwise
completely.
Close drain valve.
2.
Plug the Air Compressor Power Cord
3.
into a grounded 120 V electrical outlet.
REV 10b
