Page 4
SKU 95370
for technical questions, please call 1-800-444-3353.
do not overreach. keep proper footing and balance at all times.
Proper footing
and balance enables better control of the power tool in unexpected situations.
use safety equipment. Always wear eye protection.
Dust mask, nonskid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions. Al-
ways wear ANSI-approved safety goggles and a dust mask/respirator when using
or performing maintenance on this tool.
TOOL uSE ANd CARE
Do not force the tool.
use the correct tool for your application.
The correct tool
will do the job better and safer at the rate for which it is designed. Do not force the
tool and do not use the tool for a purpose for which it is not intended.
do not use the power tool if the Power Switch does not turn it on or off.
Any
tool that cannot be controlled with the Power Switch is dangerous and must be
replaced.
disconnect the Power Cord Plug from the power source before making any
adjustments, changing accessories, or storing the tool.
Such preventive safety
measures reduce the risk of starting the tool accidentally.
Always unplug the tool
from its electrical outlet before performing any inspection, maintenance, or
cleaning procedures.
Store idle tools out of reach of children and other untrained persons.
Tools
are dangerous in the hands of untrained users.
Maintain tools with care. keep cutting tools sharp and clean.
Properly main-
tained tools with a sharp cutting edge are less likely to bind and are easier to control.
Do not use a damaged tool. Tag damaged tools “Do not use” until repaired.
Check for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the tool’s operation. If damaged, have the tool
serviced before using.
Many accidents are caused by poorly maintained tools.
use only accessories that are recommended by the manufacturer for your
model.
Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or main-
tenance performed by unqualified personnel could result in a risk of injury.
5.
6.
1.
2.
3.
4.
5.
6.
7.
