SKU 90399
For technical questions, please call 1-800-444-3353.
Page 5
Operation (continued)
FIGURE 1
Hammer Face (10)
(Pounding on this with the
Hammer (49)
shoots out a
staple.
Air Inlet (47)
Magazine (30a)
Arm (48)
Sleeve (36a)
Shoe (28)
Staples exit the
Stapler from the
bottom of the
Shoe (28)
.
Loading the Stapler
Warning!
Disconnect the Stapler from the air compressor whenever loading or servicing.
After disconnecting the Stapler from the air compressor, there could still be enough air pres-
sure to fire the Stapler. After the air compressor hose is disconnected, always fire the Stapler
repeatedly to make sure all of the air is expended. See page 6 under “Using the Stapler” for
firing instructions.
1.
Grip the
Sleeve (36a)
and pull out the
Magazine Cover (33a)
. Insert the staples inside
the
Magazine (30a)
.
Note:
Only use the size staples listed on the Specifications Chart on page 2.
2.
Use caution, the Magazine Cover (33a) will try to snap closed with force when the
Pin (38) is pressed.
While holding the
Sleeve (36a)
firmly, use a small screwdriver to
press in the Locking Pin (38) along the edge of the Magazine Cover. See
FIGURE 2
.
Assembly
- Attaching the
Arm (48)
is the only assembly required. See
FIGURE 1
and the
Assembly Drawing on page 8.
The two
Clamp Screws (44)
fit in the recessed gaps on the lower part of the
Arm (48)
.
As shown below, hold the
Clamp Screws (44)
in place around the
Body (18)
and add a
Washer (45)
and a
Nut (46)
to the threaded ends of the
Clamp Screws (44)
. Tighten them
securely.
Recessed
Gap
Clamp Screws (44)
Sleeve (36a)
FIGURE 2
Magazine (30a)
Air Inlet (47)
Hammer Face (10)
Shoe (28)
Magazine Cover (33a)
Locking Pin (38)
REV 11/04
