8
Care & Maintenance
1.
This is a precision measuring tool and
should always be handled with care and
transported within the carry pouch provided.
2.
Always turn the tool off when transporting
the laser level or moving around the job site.
3.
Whenever possible, store the tool in a dry,
shady location.
4.
When the tool is not in use or is being
stored, it is highly recommended to
remove the batteries.
5.
Calibration of the tool is recommended every
six months, if ongoing accurate levelling is
required, or an impact has occurred.
6.
The operator should check the accuracy
of the tool before precision levelling is
attempted. Failure to do so may result
in inaccurate measurements.
7.
Clean the tool with a dry, soft cloth after use in
dusty, damp or wet conditions before storing.
8.
Smudges and fingerprints may be removed
with a damp tissue or a soft, lint-free cloth.
Using the Tripod
A tripod can be purchased from your
nearest measurement tool dealer. The
below instructions are generic only and
set-up methods may vary between models.
Refer to the documentation from the
tripod manufacturer for details.
•
Extend the tripod legs to the required height
and ensure the legs are spread wide enough
so that the tripod platform is stable. Secure the
legs in place (refer to the documentation from
the tripod manufacturer for details).
•
Place the laser level onto the tripod and mount
via the male thread (5/8” into the base until
firm. Do not over tighten as this may cause
damage to the laser level or tripod.
NOTE:
adjustment methods will vary on
tripod models. Always ensure that any locking
levers are unlocked before making adjustments
and returned to the locked position when the
adjustment is complete.
If using an elevating tripod with a measuring
scale on the centre column, the height can be
adjusted as required.
WARNING!
Attaching the laser to
a tripod without the correct thread
size may cause damage.
!
NOT INCLUDED
