Centre Point 400106, Instruction Manual

FIGURE 4

FIGURE 5

FIGURE 6

6

SETUP

• 

 Select a place as close as practical  

to the work site. Ensure the location  

is clear of traffic.

• 

 Place the laser on a level surface  

such as a bench or supplied mount. 

OPERATION

Powering on (self-levelling)

• 

 To turn the instrument on, slide the power 

/ locking switch to the “unlocked” position 

(Fig.4). Self levelling will commence and the 

horizontal beam will activate (Fig.5). 

• 

 Press the line mode button on the control  

panel to cycle through the active beams (Fig.6).

• 

 If the instrument is outside the self levelling 

range the instrument will not level causing the 

laser beam to flash on and off repeatedly. If this 

occurs, reposition the instrument onto a level 

surface until the instrument can level off.

Powering off (self-levelling)

• 

 To turn the instrument off, slide the power  

/ locking switch to the “locked” position.

Tilt lock function (manual mode)

• 

 Ensure the power / locking  

switch is in the “locked” position.

• 

 Press and hold the line mode button for  

3 seconds. The horizontal line will activate.

• 

 The instrument can now be  

tilted to the desired angle.

• 

 Press the line mode button on the control  

panel to cycle through the active beams. 

• 

 To turn off the beams, press the line  

mode button until all beams are off. 

              When in tilt lock function (manual mode) 

the instrument will not self level and  

correct for vibrations and/or disturbances.

              Active laser beams will flash every four 

seconds when in manual mode.

Using the Laser (continued)

LINE

PULSE