Revision 1. 2 November 2017
© 2017 Centrica plc.
Registered office: Millstream, Maidenhead Road, Windsor, Berkshire. SL4 5GD. Registered in England & Wales No 3033654
Page 12 of 22
This allows you to create different settings only on the screen and save them to a file,
without updating the bridge configuration.
Loading the Bridge Configuration from a Configuration
11.
To exit configuration mode, disconnect the bridge from the power source.
12.
Install the bridge as explained in
13.
Reconnect the bridge to the power source.
Configuring the Bridge for Cellular Connection
Use a SIM card if you connect to the Internet via a standard GSM network.
Use a cellular stick if, for example, you connect to the Internet using a CDMA network.
IMPORTANT
Only use a cellular stick approved by Panoramic Power.
Prerequisites
For some SIM cards, the system fills details automatically in the
Connection
Setup
page. For
others, you need to get the information from the SIM card supplier or the service provider.
How to proceed
1.
In
Connection Type
select
Connect via Cellular
.
2.
Depending on the connection hardware (SIM card or cellular stick) you are using, select
Internal GSM Modem
or
External GSM Modem
. The parameters change according to the
option selected.
3.
(
Internal GSM Modem
) Use the
View cellular networks
button to verify reception of the
relevant cellular network (could take up to 30 seconds). Then enter the
APN
you received
from the cellular network operator. If required, enter PPP details.
