Revision 1. 2 November 2017
© 2017 Centrica plc.
Registered office: Millstream, Maidenhead Road, Windsor, Berkshire. SL4 5GD. Registered in England & Wales No 3033654
Page 8 of 22
•
A SIM card from your service provider, if you connect to the Internet via a standard
GSM network.
•
A cellular stick from your service provider if, for example, you connect to the Internet
using a CDMA network.
IMPORTANT
Only use a cellular stick approved by Panoramic Power.
Configuring the Bridge
This section assumes you are familiar with networking procedures.
Accessing the Bridge Web Interface
This section describes how to access the bridge web interface for configuring the relevant data
communication mode.
Prerequisite
Use Internet Explorer 9.0 (and up), Google Chrome, or Firefox to access the bridge web
interface.
How to proceed
1.
On your PC, disable your Wi-Fi and disconnect the LAN cable.
2.
Connect the bridge to the power source.
3.
Once the bridge powers up, connect the bridge to the PC using the LAN cable.
The bridge performs a self-test where all LEDs light in sequence. For information on LED
status, see
4.
Press the
Configuration
button for approximately 5 seconds, until the
LED lights solid
red.
5.
Activate your web browser. In the address bar, enter IP address
10.0.0.10
.
The
Status
page appears. It displays the current configuration.
