Centrometal CentroPelet ZS10, Technical Instructions

GB

Maintenance performed by the A.A.C.

During the first lighting it is necessary 
to ventilate the environment well, since 
during the first hours of operation 
unpleasant odours could develop due 
to fumes from the paint and the grease 
in the tuyère wrapping.

ATTENTION!

If during the normal operation of the stove, 
the temperature of the smoke reaches 
220°C  (parameter  which  can  be  modified 
by a technician) the smoke is modulated as 
follows:
• Smoke  removal  motor  set  at  the  maximum

speed;

• Pellet  loading  gear  motor  at  the  minimum

speed;

• Tangential heat exchange fan at the maximum

speed.

This  procedure  functions  to  lower  the 
temperature of the smoke. When this returns 
below the level of 220°C the stove will restore 
the speed of the three motors returning them 
to the settings before the level was passed.
If the electrical current cuts out, once it is 
restored, the display will indicate a state 
of  anomaly  and  will  read  “Fire  cool”  (flame 
present). The suction will be increased to expel 
the residual smoke.

Pictures are indicative and can differ from the original product.
Pictures are an example to understand how the product works

Operations to be performed by the 
Authorized Assistance Centre every season 
before the lighting.

• A general cleaning inside and outside.
• A careful cleaning of the exchange tubes.
• A careful cleaning and disincrustation of the

crucible and the relative cavity.

• Clean  the  motors,  checking  the  play  and

fastenings of the mechanisms.

• Clean the smoke channel (substitute the tube

gaskets) and smoke extractor fan cavity.

• Clean  pressure  switch,  sostitute  silicone

tube.

• Check the probe.
• Replace  the  batteries  in  the  clock  on  the

electronic board.

• Clean,  inspect  and  disincrust  the  lighting

resistor compartment, replacing it if
necessary.

• Clean/check the synoptic panel.
• Visually  inspect  the  electrical  cables,  the

connections and the electrical power cable.

• Clean the pellet container and verify the play

with the screw feeder gear motor.

• Replace the door seals.
• Test  functions,  loading  the  screw  feeder,

lighting,  10  minutes  of  operation  and  shut
down.

• Check the electrical parts and the electronic

components.

• Check  and  possible  cleaning  of  the

canalisation.