Centrometal CentroPelet ZS10, Technical Instructions

GB

Norms and conformity declarations

Installation

Legislation

• Our  company  declares  that  the  stove

conforms to the following norms for EC 
European Directive marking.

• 89/336 EC and 2004/108 EC (EMC directive)

and successive amendments.

• 2006/95  EC  (low  voltage  directive)  and

successive amendments.

• 2006/42 EC (machinery directive).
• 89/106 EC (construction products).
• For  installation  in  Italy  refer  to  the  UNI

10683/98  or  successive  modifications;
the technician installing the hydrothermal
sanitary system will issue the declaration
of  conformity  according  to  L.  37/2008.
The  installation  of  appliance  has  to  be  in
accordance with local and national laws and
with European norms.

• EN  60335-1  -  EN  50165  -  EN 50366  -  EN

55014-1  -  EN  61000-3-2  -  EN  61000-3-3  -
EN 14785.

Responsibility

The  manufacturer  declines  every  direct  or 

indirect, civil or penal responsibility due to:

• Poor maintenance.
• Failure to observe the instructions contained

in the manuals.

• Use  in  non-conformity  with  the  safety

directives.

• Installation in non-conformity with the norms

in force in the country.

• Installation  by  unqualified  or  untrained

personnel.

• Modifications and repairs not authorized by

the manufacturer.

• Use of non-original replacement parts.
• Exceptional events.
• Use  of  pellets  not  approved  by  the

manufacturer.

Flue

The 

flue 

must 

meet 

the 

following 

requirements:
• No  other  type  of  chimney,  stove,  boiler  or

hood vent must be connected (fig.1).

• It  must  be  adequately  distanced  from

combustible or inflammable material 
by means of an air cavity or opportune 
insulation.

• The  internal  section  must  be  uniform,

preferably circular: the square or rectangular
sections must have rounded corners with a
radius  of  no  less  than  20  mm,  a  maximum
relationship  between  the  sides  of  1.5;
the walls as smooth as possible with no
narrowed sections, regular curves and no
discontinuities, with deviations from the axis
not more than 45°.

Fig.1: methods for installing the flue

YES

NO

NO