Centrometal CentroPelet ZS10, Technical Instructions

GB

Positioning

The stove is furnished with an electrical cable 

to connect to a 230V 50Hz socket, preferably 
with a thermal-magnetic switch. Variations in 
tension of more than 10% can compromise 
the stove (if not already present, an adequate 
differential switch should be provided).

The  electrical  system  must  comply  with  the 

norms; verify in particular the efficiency of 
the ground circuit. The electrical feed cable 
must be of a diameter adequate to the power 
of the device.

The stove must be completely level. Verify the 

weight bearing capacity of the flooring.

The  placement  of  the  stove  within  the  living 

environment is determined so that the 
environment is heated in a uniform manner. 
Before deciding where to place the stove, 
keep in mind that:

• The air used for combustion must not come

from a garage or a space without ventilation 
or air exchange, but from a free space or the 
outside;

• The  stove  should  not  be  installed  in  a

bedroom;

• Rather it is preferable to install the stove in a

large, central room of the house to insure the 
maximum heat circulation;

• A grounded electrical connection is obligatory

(if the cable issued with the stove is not long 
enough to reach the closet socket, use an 
extension cable along the floor).

Fire Safety Distance

The  stove  must  be  installed  respecting  the 

following safety conditions:

• Minimum  distance  from  the  sides  and  the

back  must  be  40  cm  from  moderately 
inflammable material;

• Easily inflammable material must not be place

closer than 80 cm in front of the stove;

• If  the  stove  is  installed  on  an  inflammable

pavement the stove must be placed on a 
slab of material that insulates it from the heat 
that is wider at the sides by 20 cm and in the 
front by 40 cm;

• Do not place objects in inflammable material

or any material that can compromise the 
operation of the stove on the stove or within 
the safety distance;

• In  addition,  it  is  advisable  to  keep  all

elements of combustible or inflammable 
material such as beams, wooden furniture, 
drapes, inflammable liquids, etc. outside the 
radiance area of the stove, and in any case 
at least 1 m from the heating block (Fig. 6);

• In  case  of  connection  to  wooden  walls  or

other inflammable material, it is necessary 
to insulate the smoke discharge tube with 
ceramic fibre or another material with the 
same characteristics.

Fig. 6: minimum distance of objects

40 cm

20 cm

20 cm

40 cm

5/7 cm

40 cm

80 cm