15
14 - Adjusting the cantilever
The one-sided overhang of the module support
over the outer 2-C groove profiles
(cantilever)
is
permitted up to 400 mm.
The fastening of the further clamping jaws takes
place analogous to the mounting of the previous
clamping jaws.
15a - Aligning module supports
There are two distance gauges included in the
delivery of your mounting system that serve
as mounting aids for the other module support
profiles.
15b - Use of distance gauges
When using the distance gauge, the end faces
of the longer angle stub of the profiles should
lie on the upper reinforced edges of the module
support profiles. The short axle stub of the pro
-
files lies on the upper lip of the upper module
support profile.
In the lower module support profile, the distance
gauge also lies with the shorter axle stub on the
upper lip of the module support profile
The module supports below may not be walked
upon when aligning and installing the module
supports.
max. 400 mm
Summary of Contents for CENPAC 3 Series
