19. How to set up additional features on
the D5-Evo controller
page 36
Section 20 provides the full menu of features that can be set up on the system. An
explanation of each feature is provided in Section 21, Controller features
When setting up the
D5-Evo
system via the LCD display, all the steps that have to be
followed are clearly provided via the display. It is only necessary to note the following:
To get into setup mode, press the enter
button for two seconds and follow
( )
the instructions provided from there
The buttons provided on the controller for navigating the system are not marked
because at each step during the setup, the function given to each button is provided
on the display
When not in setup mode, i.e. normal mode, the ( ) button is used as a
test
button
for operating the system
The triangular up or down ( ) buttons are used to scroll through the diagnostic
screens
For each feature a factory default setting has been programmed into the controller.
Referred to as an operating standard or profile, these defaults have been
determined to suit the requirements of the specific region where the installation is
being carried out. It is only necessary to change a feature where the default does
not suit the installation. When selecting any feature in the menu, details of the
current setting stored in the controller are displayed
Refer to Section 22 for the Schedule of factory defaults for each feature
