page 33
www.centsys.com
The following provides additional information of each menu.
Menu 1 and Menu 2
Refer to the basic controller setup for more information (Section 5).
Menu 3 - Autolower
The
SECTOR II
can be set to Autolower the boom under many different circumstances.
The following options are available;
3.1 Autolower status
If enabled, the boom pole will automatically lower after a preset Autolower time.
3.2 Autolower time
The Autolower time can be set anywhere from 1 to 240 seconds (four minutes).
3.3 Autolower override
If turned on, this menu provides a way for a user to temporarily turn off Autolower.
To achieve the functionality, the user would activate and maintain the Memory Input
for longer than the Autolower Override Time. Activate Memory Input to clear the
override.
3.4 Autolower advanced options
Set the conditions under which the boom pole will automatically lower. More than
one condition can be selected:
• Autolower fully raised
Automatically lower the boom if boom pole is fully raised
• Autolower on partly raised
Automatically lower the boom pole if it has been stopped partially raised
• Autolower on partly lowered
Automatically lower the boom pole if it has been stopped partially lowered
Menu 4 - Modes of Operation
Refer to the Pre-installation Buyer's Guide for more infor
mation.
Menu 5 - Run Profile
The run profile of the
SECTOR II
can also be set. This allows the overall behaviour of the
traffic barrier to be fine-tuned in order to meet the user’s unique requirements;
5.1 Lock boom pole at endpoints:
Fail-safe mode
In the event that electronic locking is not required and mechanical locking is
preferred, refer to Section 10.3 to adjust the endstops into their locking positions.
• Lock when raised - mechanically lock boom pole in raised position.
Use manual override key to override
• Lock when lowered - as per above for lowered position
• Holding force - force used to automatically hold the boom pole in the raised or
lowered position if ‘lock at endpoints’ is not selected
ADVANCED CONTROLLER SETUP
SECTION 7
Summary of Contents for SECTOR II
Page 82: ...page 82 www centsys com Notes...
Page 83: ...page 83 www centsys com Notes...
