page 34
www.centsys.com
The locking endstops must be set for the locking feature to be effective.
5.2 Raise when mains fail
If enabled, the boom pole will raise in event of a mains power failure. Boom pole
will remain raised until mains power is restored.
5.3 Spike interface
If enabled, this facility allows the
S-SERIES
controller to communicate with
co-installed CLAWS roadway spikes.
5.4 Pre-raising delay
Allows a delay between a valid trigger signal and the boom pole raising.
Can activate a warning light during delay if the TVI is not selected.
(Refer to pre-flash modes of the courtesy light feature, for more details.)
5.5 Pre-lowering delay
Identical to above, except for boom pole lowering.
5.6 Raising speed
Sets the maximum raising speed in degrees per second.
5.7 Lowering speed
Sets the maximum lowering speed in degrees per second.
5.8 Ramp-up distance
Sets the ramp-up distance in degrees.
5.9 Ramp-down distance
Sets the ramp-down distance in degrees of travel of the boom pole when stopping.
5.10 TRG stop distance
Sets the angle over which a moving boom pole will stop after a trigger signal is
received.
5.11 Loop stop distance
Sets the angle over which a moving boom pole will stop after a safety input is
triggered.
5.12 Crawl distance
Sets the final crawl distance in degrees of travel of the boom pole when reaching an
endpoint.
5.13 Torque limit
Sets the maximum torque delivered by the motor. This is useful in cases where
limited push force is required.
Menu 6 - Loop Detector
Refer to the basic controll
er setup for more information (Section 5).
Menu 7 - Traffic Light
The
S-SERIES
controller provides the facility to control an externally-mounted traffic
light (The traffic light is an ancillary product and may be purchased from Centurion
Systems (Pty) Ltd
). The purpose of the traffic light is to signal to road users that it is safe
to travel across the barrier threshold.
ADVANCED CONTROLLER SETUP
SECTION 7
Summary of Contents for SECTOR II
Page 82: ...page 82 www centsys com Notes...
Page 83: ...page 83 www centsys com Notes...
