Release Chor d
Fig 11
Fig 12
Release Cord
Fig 10
Fig 9
10
3.
4.
5.
6.
Adjusting Release Cord
Engaging And Disengaging The Drive Unit
Fitting of Weight Bar
Fixing Of Curtain To Drum Wheel
3.1
Unfurl the Red Disengage Cord and cut it to an appropriate length so that its end hangs approximately
1800mm above the garage floor.
4.1
To disengage the Drive Unit from the garage door pull down on the Red Release Cord. (Fig.11)
4.2
To engage the Drive Unit to the garage door pull down once more on the Red Release Cord.
5.1
Fit the weight bar to the top edge of the garage door bottom rail as depicted in Fig.12
6.1
The garage door curtain must be secured to the drum wheel with suitable fasteners such as self drilling
4.3
Important Note: Always disengage the Drive Unit with the garage door in the fully closed position.
4.4
Important Note: If attempting to disengage the Drive Unit from any position other than with the
garage door fully closed ensure that there are no persons and/or property near or directly under
the path of the garage door.
INSTALLATION INSTRUCTIONS
