page 52
www.centsys.com
Learning procedure
Enter Learn mode (Refer 10.1). Using the ‘+’ and ‘-’ buttons, select ‘ao’. Press and hold
the transmitter button until the display flashes “ao” and buzzer beeps four times.
9.2.5. Learn all buttons function
If function five is selected, all the buttons of a remote control or wall switch will be
learned in the following configuration and sequence:
1. Button 1 – Open/Stop/Close
2. Button 2 – Light
3. Button 3 – Lock
4. Button 4 – Autoclose override
Operation
The operation of Function Five will be according to the four different functions
described previously.
Learning procedure
Enter Learn mode (Refer 10.1). Using the ‘+’ and ‘-’ buttons, select ‘bu’. Press and hold
the transmitter button until the display flashes ‘bu’ and the buzzer beeps five times.
9.2.6. Open Only Function
This function allows associated button to only open the door.
Operation
Momentarily pressing the associated button will open the door from any position. If the
door was closing the door will stop and re-open. This function has no effect if the door is
open.
Learning procedure
Enter Learn mode (Refer 10.1). Using the ‘+’ and ‘-’ buttons, select ‘oo’. Press and hold
the transmitter button until the display flashes ‘oo’ and the buzzer beeps six times.
9.2.7. Close Only Function
This function allows associated button to only close the door.
Operation
Momentarily pressing the associated button will close the door from any position. If the
door was opening the door will stop and close. This function has no effect if the door is
closed.
Learning procedure
Enter Learn mode (Refer 10.1). Using the ‘+’ and ‘-’ buttons, select ‘co’. Press and hold
the transmitter button until the display flashes ‘co’ and the buzzer beeps seven times.
S
ECTION
9
PROGRAMMING
REMOTE
CONTROLS
