Page 39
20. Setting up the limits and features
for the SECTOR barrier
Exit
Go
Up/Dn
Encoder
Aux Out
Aux 12V Out
Lck/Stp
MI
NMI
Com
Raise
Lower
Status
Com
Aux IO
Menu level
Menu level
Setting up the limits
When setting up the
SECTOR
barrier system via the LCD display, all the steps that have
to be followed are clearly provided via the display. It is only necessary to note the
following:
!
Press and hold the oblong enter ( ) button for two seconds to enter
Setup Mode
!
If powering up for the first time (ex-factory), select the required profile that will suit
the specific region
(ZA - for South Africa, CE - for Europe and UL325 - for North America/Canada )
!
With this set, the system will automatically proceed to the limit setup menu. Follow the
on-screen instructions to complete the setup procedure
!
If powering up at any stage after this, press and hold the oblong enter ( ) button
for two seconds
!
Select the
Limits Menu
by pressing the oblong enter ( ) button. Follow the
onscreen instructions to complete the setup procedure
The profile is compliant with UL325, but the barrier is not certified
Setting up additional features for the SECTOR barrier
The
SECTOR
navigation map that follows, provides the full menu of features that can be
set up on the system.
A brief explanation of each feature is provided in the section,
‘Controller features’
.
When setting up additional features, all the steps that have to be followed are clearly
provided via the display. It is only necessary to note the following:
!
To get into
Setup Mode
, press the oblong
enter
( ) button for two seconds and
follow the onscreen instructions
!
The buttons provided on the controller for navigating the system, are not marked
because at each step during the setup, the function given to each button is provided
on a new or defaulted controller, the LCD will display the default on the display
FIGURE 38. SECTOR CONTROLLER