Page 47
Menu 6 - Loop detector
!
!
!
!
!
!
!
!
ILAC (Inductive Loop Autoclose) Control
Causes the boom to Autolower as soon as the closing inductive loop is cleared,
ie. the vehicle moves off
FRX (Free-exit) Loop Direction
Allows a single access point with bi-directional traffic to make use of a free-exit
loop. Due consideration must be given to closing and free-exit loop positioning
Loop Alarms
While the boom pole is lowered, this feature allows the following alarms.
Presence Alarm -
Activates an alarm if the closing loop has been
continuously activated for a predefined time. The alarm will remain activated
while the closing loop is activated
Presence Time
- The time for which the closing loop must be continuously
activated before the alarm is activated
Break-in Alarm
- Activates an alarm if the closing loop is activated while the
boom is lowered. The alarm remains active while the closing loop is
activated, and for a period of 30 seconds thereafter. This time is fixed
Alarm Output
- This menu item configures the different alarm outputs
&
Crawl Distance
Sets the final crawl distance in degrees of travel of the boom pole when
reaching an endpoint
&
Torque Limit
Sets the maximum torque delivered by the motor. This is useful in cases where
limited push force is required
&
Loop Stop Distance
Sets the distance over which a moving boom pole will stop after a safety input
is triggered
Menu 7 - TVI (Ticket Vend Interlock) output
Configure TVI output for the specific purpose or as a Courtesy Light. If
configured as a Courtesy Light, light will switch on for a timed period every time
the boom is activated.
TVI Output Polarity
Configure output as a normally-closed (NC) or normally- open (NO) contact
The TVI output when configured to Courtesy Light time
The Courtesy Light time can be set from four seconds to ten hours
!
!
!
The TVI output when configured to light profile
Select operation of Courtesy Light according to four different modes