NEO 940C & 800C
Page 10
BUILD PHOTOS (USING NEO 600 AS EXAMPLE)
Assemble the lower frame plate and alumi-
num threaded arm mounts. (Quadcopter NEO
shown as demo)
Install the distributing panel hex posts on the
UPPER frame plate. NOTE: lower frame plate
shown.
Select type of battery connector (not includ-
ed) and solder all ESC and DJI BEC/PMU on
power distribution panel.
It is optional to add a disconnect for the BEC for
quick removal from the power distribution panel.
Photo shows a completed power distribution
board.
Assemble the arms as shown on page 4.
Install the power distribution board in between-
the lower frame plate and the landing gear
plate.
1
4
2
3
5
6
Install the multi-rotor controller on the lower
frame plate as shown.
Insert plastic “T” joints over the aluminum landing
gear tubes and use the set screws and self tap-
ing screws to lock together.
Make two sets of gear assemblies to complete
the landing gear.
Take a moment to get an understanding of which wires relates to which connectors and take the lower
frame plate and lay it out.
7
8
9
10
11