Lap belts with retractors may or may not hold
a car seat securely.
Follow these steps to determine if you have a
retractor system that will hold car seat securely:
a. Pull belt all the way out.
b. Allow belt to retract about 6 inches (15 cm).
c. Pull out on belt again.
If belt is locked and you
cannot
pull the belt out
any further, you have an Automatic Locking
Retractor which may be used with a car seat.
Remember, when installing a car seat, pull belt
all the way out, buckle belt, and then tighten.
If you
can
pull the belt out again (step c), you
have an Emergency Locking Retractor which
must not
be used with a car seat.
VEHICLE SEAT BELTS
(continued)
The locking latch plate on some seat belts may
slip and loosen after being buckled on car seat if
positioned at a certain angle. If this happens,
flip latch plate over
(fig. a)
and re-buckle. Test
installation again to see if this works. If not,
move car seat to another seating position.
18
(fig. a)
Retractor
❃
Lap Belts - Manually Adjustable
❃
Lap Belts - With Retractor
Flip
Summary of Contents for Avanta
