Radikal Gasser
Page 21
1
2
3
5
4
4
7
8
9
11
10
6
CLUTCHBELL ASSEMBLY
CNM4x4SS
CNBB1015
CNBB513
CNBB1524
CNBB511
BAG 2
The Radikal uses the regular starting shaft and hex coupler as to align
the clutch to the clutchbell. Clean both the starting shaft and the inside
race of the bearing inside the clutchbell and the inside race of the top
starting shaft bearing. Apply a small amount of Red threadlock posi-
tioned just above where the bottom clutchbell bearing will sit on the
starting shaft. Slide the starting shaft up through the bearing blocks.
Apply a small amount of medium threadlock to the top of the starting
shaft and slide the hex coupler in place aligning the flat spot with one of
the holes. Apply medium threadlock to the two M4x4 set screws and
tighten in place.
Clean the top of the pinion gear and the inside surfaces of both the upper
and lower bearings inside the clutch shaft bearing block using alcohol.
Apply a small amount of Red threadlock to the top edge of the clutch gear
where it will contact the bearing. Press the bearing block in place, firmly
seating the bearing against the top of the pinion gear.
HW6007G
HW6007GS
HW6043A
HW6013G
HW6006
No.
Description
Qty
1
2
3
4
6
7
5
8
9
10
11
CNBB1015
Part #
Set Screw(
无头内六角螺丝
)M4x4
2
CNM4x4SS
6mm Hex Coupler(
六角启动头
)
1
HW6002
1
Bearing(
滚珠轴承
)5x13x4
CNBB513
2
Bearing Block(
轴承座
)
4
Long Hex Spacers(
六角铝柱
)L=52MM
Alloy Drive Gear 14T For LT Version(
合金传动齿轮
)
1
HW6043B
7
Alloy Drive Gear 16T For HD Version(
合金传动齿轮
)
1
Bearing(
滚珠轴承
)15x24x5
CNBB1524
1
Clutch Bell Assembly(
离合器罩
)
1
1
Bearing(
滚珠轴承
)5x11x4
CNBB511
Starting Shaft(
启动轴
)
1
1
Bearing(
滚珠轴承
)10x15x4