Radikal Gasser
Page 41
CNM3x6ST
CNM2x5ST
1
2
3
4
6
5
CANOPY
1
6
1
2
Tinted Windshield(
透明罩
)
Screw(
螺丝
)
Canopy(
机头
)
Canopy Grommets(
橡皮环
)
2
1
CNM3x6ST
M3x6 Phillips Tapping Screws(
尖尾螺丝
)
Canopy Mount(
机头固定座
)
CNM2x5ST
HI6133G
HI6130G
CN2210A
HI3129C
No.
Description
Qty
1
2
3
4
Part #
5
6
1
Decal Sheet
HI6131G
7
When drilling the holes into
the canopy for the grommets,
do not oversize these holes. If
you do this, the grommets will
not stay in place. If you have
a hard time mounting the
grommets onto the canopy
standoffs, you can use a dab
of oil.
Prior to making the holes for the canopy chin
mount, you should mount your canopy to the
mechanics making sure any linkages, servos,
etc...are not touching the canopy. It may be nec-
essary to cut the canopy to avoid binding these
linkages. Also, make sure your muffler is not
touching the canopy as the canopy will melt.
It will be necessary to cut the windshield out from the mold.
It is recommended to use curved hobby scissors for this pro-
cess. If the lines are not smooth, you can use 200 grit sand-
paper to sand the edges.
Apply the decals as shown. If you need a better reference,
the box cover is also a good image to follow.