Radikal Gasser
Page 5
HEAD ASSEMBLY (HD VERSION)
1
2
3
4
5
6
Take special care when pressing in these bearings. Do not
press in on the inner sleeve of the bearing
7
8
9
10
Do not secure all the screws until lining up the
components in the following steps.
CNBB0730
CNBB0840
HI3167G
CNM3X14BHCS
CNM3X6BHCS
CNM2.5X8CS
Insert one ball bearing into each bearing cup and insert into
the offset plate. Apply one small drop of slow cyanoacrylate
glue (Slow CA) to the joint between the backside of the
bearing cup and the offset plate. Insert one ball
bearing into each tie bar. Using an available
M3 socket cap screw, form threads
into both ends of the tie
bars. Insert one
M3x6 button head
screw through
the right side
hole of the
offset plate
and thread
into one
tie bar.
M a k e
t w o
i d e n t i c a l
s u b a s s e m -
blies . Note that
the bearing cups face
outwards from the head
block. Insert one M3x14 but-
ton head screw through the tie
bar bearing, slide one steel spacer
and carefully apply Medium threadlock to
the exposed threads and insert into the right
side of the head block. Do not overtighten. Repeat
for the second sub-assembly. Once complete apply
a small amount of slow cyanoacrylate glue and insert one
CNLR1020 special long thread ball into each offset plate to com-
plete the assembly.
Do not open all the bags prior to starting assembly. Open the bags step by step as you go through the instruction manual. The
components are bagged to make assembly easier. The next few pages will pertain to the assembly of the head. Please follow
the instructions based on the head type you own. Make sure to apply threadlock to any screws going into metal.
BAG 1
No.
Description
Qty
1
2
3
4
5
Part #
6
7
8
9
10
NX Rotor Head Yoke(
主旋翼中心座
)
Seesaw Tie Bar Set(
平衡杆控制臂
)
2
2
2
2
2
2
CNBB0730
CNBB0840
HI3167B
HI3167G
CNM3X14BHCS
HI3167G
2
2
1
HI6160A
CNM3X6BHCS
CNM2.5X8CS
2
Stainless Ball, 3mm Thread, Medium(M3
球头螺丝
)
Seesaw Offset Plates(
平衡杆固定片
)
3x7x3 Ball Bearing(
轴承
)
M3x6 Button Head Cap Screws(
伞头螺丝
)
4x8x3 Ball Bearing(
轴承
)
3x5x6 Seesaw Tie Bar Set(
铁套
)
M3x14 Button Head Cap Screws(
伞头螺丝
)
M2.5x8 Cap Screws(
杯头螺丝
)
CNLR1017 L=6.5MM
CNLR1017