9. Trim fascia:
From edge of fascia opening, measure and mark 3/4” [19.05mm]
over. Measure over 2-1/2” [63.5 mm] down 1-1/4” [31.75 mm] . Carefully trim,
fascia as shown in figure 5.
10. Reinstall fascia:
Lift fascia over receiver tube being careful not to scratch
fascia. Starting from the center of the vehicle lineup and gently reinstall the rear
fascia and all fasteners in reverse order steps 1-4. (Note: reattach any wiring
harness if removed)
8. Tighten all M8 CL8.8 fasteners with torque wrench
to 20 Lb.-Ft. (27 N*M).
Proper torque is needed to keep the hitch secure to
the vehicle when towing.
7. Install hitch and bumper
: Lift hitch into position, resting on bolt installed in step 6. Raise bumper into
position over hitch and install bolts (item 1) and conical washer (item 2) as shown in figure 1. Once the hitch
is secured with several fasteners to support it, remove the bolt used in step 6 and install properly. Center
hitch on vehicle and tighten. If tab on bumper interferes with installation it may be necessary to use a
hammer to bend tab on bumper flush with bumper.
2-1/2” [63.5 mm]
1-1/4” [31.75 mm]
3/4”
[19.05 mm]
Figure 5
Tab
Reese Towpower products are your right choice if you need quality and reliability.
