3
Rock on!
-
Nik S Azam
2) QUICK SETUP (for instant gratification)
1)
Plug your guitar using a 1/4” instrument cable into the INPUT on the right of the front panel
2)
Plug a suitable power cable from the Chupa’s rear panel MAINS cable inlet to your wall power receptacle
3)
Plug the Chupa into your speaker cabinet using 1/4” speaker cable
4)
Set the OUTPUT SELECTOR to the match the impedance of your speaker cabinet
5)
Set all rotary controls on the front panel to 12:00 (clock face)
6)
Set ERA control to the far right position
7)
Set BRIGHT 1 and 2 to the far left positions
8)
Set front panel POWER switch in the “1” position (down position, with adjacent STANDBY switch in the “0”/up position)
for 30 seconds to allow tube filaments to warm up
