DF Tuff
Page 13 of 31
Step 5: Gently flip the rear cover back onto the rear of the enclosure,
carefully to fold the wires back into the enclosure without pinching
them. Secure the rear cover by installing the screws to hold the cover in
place.
7.2
Charge the Battery
Batteries are shipped uncharged. An uncharged battery must be
charged for a period of 66 hours before it will become fully charged,
‘formed’ for maximum life,
and available for backup power use.
Power the unit from the AC/DC wall adapter or PoE. The Battery will
commence charging.
New clocks will automatically form the batteries. The forming procedure
will fully charge the battery over a period of about 24 hours, then allow
it to discharge before charging it again and repeat this until 3 cycles
have been completed. If a battery is replaced, you can initiate the
battery forming sequence manually by using the administrative function
provided. The clock is fully functional during the forming process
Notes
:
1.
A system running on battery power can be shut down by pressing
the reset button which is located alongside the rear connectors.
2.
If operation on battery power is attempted before the battery
reaches full charge, there may be insufficient voltage to transition
to battery powered operation and the system will stop operating.
Place the system back on AC/DC wall adapter or PoE power. Press
the reset button if necessary to shut it down.
8
CAMERA USE APPLICATION NOTES
The following best practices are recommended for recording punches
using camera validation:
