V2.0
10.
[ Other technical documents]
10.1
Point to Point / Multi-Point for WDS settings
The WDS function is applied in the wireless AP mode. This function is mainly used for point-to-point
wireless AP bridging. For the setting method,You can
refer to the manual 5.5.5 “WDS Setting”
. This
document mainly guides the key WDS procedures. Can easily structure WDS point-to-point or point to
multi point applications
1)
If point-to-point bridging is used for WDS function, it is recommended to use our products to avoid
compatibility issues.
2)
If point-to-point bridging is used for WDS function, it is recommended to use our products to avoid
compatibility issues.
3)
According to the requirements to be applied to 2.4G or 5G, please make sure that each wireless AP
sets a set of same channels
(please refer to the manual 5.5 "Wireless Configuration" (Radio 0 or
Radio 1 or Radio 2 Setup)
4)
Restart after confirmation will complete WDS point-to-point bridging,
please refer to the manual
5.5.6 "WDS Status
" to confirm the RSSI value.The value If show to “-1” indicates that the
connection is not successful, please re-confirm whether the configuration file follows the above
instructions, or between APs. Signals are blocked by interference.
5)
Please refer to WDS setting page, please set the MAC address information of other wireless for the
wireless AP correctly. If two bridges, Radio A and Radio B, are used as examples, the MAC address
information of Radio B must be entered in the MAC address list of Radio A of the site, and, the MAC
address information of Radio A must be entered in the MAC address list of Radio B of the site.
Ps, The RSSI value is recommended to fall between 40 ~ 60. If over the RSSI value means the AP is
too close to the AP.If below the RSSI value means the signal is not right or the distance is too far.
Remark:
Because the WDS application is in the wireless AP mode, if the WDS function is enabled, it will be
an AP + WDS application. If the wireless AP is not required to use the WDS function purely,
you
can refer to the manual 5.1 "VLAN Setup" instructions,
turn off the wireless AP, as shown below.
Summary of Contents for SEFA OW-500 A1
Page 75: ...V2 0 ...
Page 146: ...V2 0 ...
