Carbon Brushes
Ensure the tool is unplugged from the power supply and allow the tool to sit unused for
50 hours before checking the brushes.
Remove the brush cover, remove the carbon-holder cap then remove the brush.
The carbon brush should be at least 5mm long. In the case of excessive wearing or
excessive sparks, replace both brushes with carbon brushes of identical characteristics.
Maintenance
WARNING: For maintenance and cleaning, always remove the plug from the electric
power supply. Never use water or other liquids to clean electric parts. It is
recommended that the tool power be supplied by a residual current device with a rated
residual current of 30mA or less.
Each day of use, check that all screws and nuts are securely fastened. Except for the
procedures explained in this manual, there is no specific maintenance required.
The cleaning of plastic components should be done with a soft damp cloth with some
mild soap. Never submerge the unit into any liquids and do not use any alcohols, spirits
or abrasive detergents.
If replacement of the supply cord is necessary, this has to be done by a Kogan service
technician or a qualified electrician to avoid a safety hazard.
Contact the Kogan customer support team for further information.
https://www.kogan.com/au/contact-us/
or 1300 304 292
Disposal
Waste electrical products should not be disposed of with your
household waste. Please recycle where adequate facilities
exist. Check with your local authorities for recycling advice.
5
Summary of Contents for CTJCKHMDEMA
Page 1: ......
